On the Analogy Between Vehicle and Vehicle-Like Cavities With Reverberation Chambers
Explore this paper's citation graph
- Type
- article
- Published
- 2014-10-17
- Cited by
- 12
- References
- 26
- Access
- Open access
- OpenAlex
- https://openalex.org/W1968008783
- Semantic Scholar
- https://api.semanticscholar.org/CorpusID:43674467
Keywords
Isotropy, Electromagnetic reverberation chamber, Wireless, Coherence bandwidth, Acoustics
References
- Effects of vehicle furnishings on performance of aperture mounted multi-band conformal automotive antenna
- Frequency stirring: An alternate approach to mechanical mode-stirring for the conduct of electromagnetic susceptibility testing
- A Study on Frequency Diversity for Intra-Vehicular Wireless Sensor Networks (WSNs)
- Field distributions within a rectangular cavity with vehicle-like features
- Electromagnetic fields in cavities: Deterministic and statistical theories [Advertisement]
- WIRELESS NETWORKS IN VEHICLES
- Reverberation and Absorption in an Aircraft Cabin With the Impact of Passengers
- Vehicles without wires
- Impact of internal dielectric components for vehicle models
- An Impulse Response Model and Q -Factor Estimation for Vehicle Cavities
- Noncoherent Capacity of Underspread Fading Channels
- A Sixty GHz Intra-Car Multi-Media Communications System
- Computed field distributions within a passenger vehicle at 2.4 GHz
- In-vehicle WLAN radio-frequency communication characterization
- Measured and computed in-vehicle field distributions
- Bivariate Statistical Approach for “Good-but-Imperfect” Electromagnetic Reverberation
- Validation of simple estimates for average field strengths in complex cavities against detailed results obtained from a 3D numerical model of a car
- Use of reverberation chamber to simulate the power delay profile of a wireless environment
- Investigations to extend the lower frequency limit of reverberation chambers
- Absorber loading study in FOI 36.7 m3 mode stirred reverberation chamber for pulsed power measurements
Cited by
- Channel Propagation Measurement and Modeling for Vehicular In-Cabin Wi-Fi Networks
- Performance Evaluation of Concurrent IEEE 802.11 Systems in the Automotive Domain
- Impacts of Absorber Loadings on Simulating the Multipath Channel in a Reverberation Chamber
- IEEE 802.11 Systems in the Automotive Domain: Challenges and Solutions
- Routing and link performance assessment of a wireless sensor network in a reverberation chamber with different absorber loading conditions
- Stochastic Modeling of Impulse Responses in Reverberating Environments
- On-Site Automotive Environment Measurements for a Risk-based EMC Approach
- Electrical Fields in Vehicular Cavities During Reverberation Chamber EMC Immunity Test
- Investigation of Real Dynamic Automotive Electromagnetic Environment Measurements
- The investigation of specific absorption rate measurement system for intelligent connected vehicles and its uncertainty analysis.
- Efficient Antenna Design for Vehicular Communication
- Antenna Design and Performance Analysis for V2V Vehicular Intelligent Transportation System
Related papers
- Wideband Propagation Channel Parameters Measurement Inside an University Building
- Use of Absorption Cross Section to Predict Coherence Bandwidth and Other Characteristics of a Reverberation Chamber Setup for Wireless-System Tests
- Acoustic design of a reverberation chamber
- Delay spread and coherence bandwidth in reverberation chamber
- Delay spread measurements and characterization in a special propagation environment for PCS microcells
- Time delay and coherence bandwidth measurements at 60 GHz in an indoor environment for WLANs
- Statistical Characterization of the Indoor Low-Voltage Narrowband Power Line Communication Channel
- Comparison of small-scale parameters at 60 GHz for underground mining and indoor environments
- Experimental Broadband Channel Characterization in a Sea Port Environment at 5.8 GHz